- Issue Time
When machine parts are worn out, their service life will be greatly reduced. This article will specifically introduce methods to reduce the wear of machine parts.
If machine parts fail due to wear, it may cause machine failures, and more serious equipment accidents may occur. Therefore, we must maintain the machine parts in place. The following is the specific method to reduce the wear of machine parts.
Keep working at rated load
The nature and size of the working load of construction machinery have an important influence on the loss of machine basic parts. Generally speaking, the wear of parts will increase with the increase of load. When the load on the part is higher than the designed working load, its wear will increase. Under the same conditions, the stable load has less wear on the parts than the high-frequency dynamic load, fewer failures, and longer life.
Prevent part corrosion
Corrosion acts on parts of the machine, sometimes it is not easy to be found, easy to be ignored, and more harmful.
Rainwater, chemical substances in the air, etc. penetrate into the machine through the pipes and gaps of the machine parts and corrode the parts. Continued work of corroded parts will also accelerate the wear and tear of the machine and increase machine failure. This requires managers and operators to adopt reasonable construction arrangements based on the local weather conditions and site conditions at the time to minimize the harm of chemical corrosion to machine parts.
Clean machine parts in time to reduce the impact of machine impurities
Machine impurities generally refer to materials such as dust, soil, and some metal scraps, grease stains, etc. produced by the construction machinery during use. Once these impurities reach between the working surfaces of the machine, their harm is great: it not only increases friction and fuel consumption; but also damages the lubricant film and scratches the mating surface.
Keep parts at a reasonable temperature
At work, the temperature of each component has its own normal range. Too high or low temperature will affect the strength of parts, so it is necessary to control the temperature of some parts with coolant and lubricating oil to make them work in a reasonable temperature range.
Because machine parts are directly related to the operation of machinery, we have a lot of things to pay attention to for the maintenance of machine parts. If you want to know more about machine parts after reading the above, please contact us, we can provide you with professional consultation and detailed solutions.
As a professional parts supplier, we have advanced processing equipment and strict quality control to provide customers with high-quality and reliable products at competitive prices. At the same time, we also provide thoughtful one-stop service. If you want to know more about our products, such as CNC precision machine parts, please contact us immediately!